Detailed Product Description

Specification and Type

We can supply various FRP pipes and carry out the advanced ASTM,AWWA and ASME standard, including utilidors,cable protection pipe, pipe with sand filler etc.

1. Flat End Pipe with Butt Joint

    Diameter: DN 10-12000mm

    Length: 1800-12000mm

2. Spigot and Socket joint Pipe

    Diameter: DN 10-4000mm

    Length: 1800-12000mm

3. Pipe Fittings:

    Tee Diameter: DN 10-7000mm

    Flange Diameter: DN 10-700mm

    Reducer Diameter1 : DN 15-7000mm; Diameter2: DN 10-5000mm; Length: 37.50-5000mm

    Elbow Diameter: DN 10-5000mm

4. FRP Pipe with Sand Filler (FWPSP)

    SN : SN2500, SN5000, SN10000

    Pressure: 0.25-54.0MPa

    Diameter: 300-4000mm

Advantages of FRP pipes

1. Corrosion-resistance: By choosing different kinds of corrosion resistant inner liner resin, products suitable for different kinds of media, such as acid, alkali, salt, oils, seawater, organic solvent etc. can be made.

2. Light, maintenance simple and be durable.

3. Easy to install: Length of FRP pipes is not restricted by technique. It is usual within 12m considering of transportation. Nozzles are reduced by that. Installation can be done manually or by light equipment because of its lightness. it is prompt and convenient.

4. Good adaptability: pipes of DN25-4000mm are available. Pressure-resistant ability is normally below 1.6MPa. Up to 6.4MPa pressure also can be achieved to meet special requirement of customers.

5. Higher conveying ability: the smooth inner surface (N<=0.0084) makes it higher circulating ability and also save energy of the pump, prolong service life of the project.

6.Lower permeability: Well sealed joints and longer pipe length make it lower permeability than the traditional materials.

7. Strict testing standard: With the advanced testing equipment, our factory carries out advanced ASTM, AWWA and ASME standard to ensure products quality.

8. Low cost in life cycle: Because of the long service, no maintenance, low installation and transportation cost, FRP products have low cost in life cycle in terms of general economic efficiency.